Sensors, Electronics and Prototyping

Processed Acceleration Data incorrect

Welcome to Redshift Labs Forums UM7 Product Support Processed Acceleration Data incorrect

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #729
    Jason Greenberg
    Guest

    hello,

    I am having issues getting the correct processed Accel. data from the UM7 as was shown in the videos found on the product page.

    I followed most of the steps shown in the videos found on the product webpage however when I go to graph the Processed Accel data using the CHR Serial Interface instead of the getting x=0, y=0 and z = -1, I have y= 0, z=-1 and x = -2.

    Is there some additional calibration or other procedure, that I am supposed to be doing or is there something wrong with the IMU chip itself?

    Any help would be appreciated.

    Thank You.

    #730

    Hi Jason,

    That’s definitely odd. I haven’t observed that behavior before. Can you open the data plot, make sure it is the active window, and take a screenshot? Use Alt-PrintScreen to just take a picture of the data graph. You can then paste it into an email and send it to support@chrobotics.om, or upload it to this forum.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.