Sensors, Electronics and Prototyping

Change Baud Rate

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #939

    Hi, I tried to change the baud rate of the UM7 LT to 57600 with the CH Serial Interface by selecting the value from configuration tab, miscellaneous …, and clicking Flash commit button, but when I disconnect the device and connect it again, the baud rate is still 115200. How can I change the value permanently?

    #940

    Hi Saddan,

    You have to reconnect at the new baud rate to send the flash commit command. Then you can cycle the power and the settings will be maintained.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.